標題: The next thing to change is the way [打印本頁] 作者: Mitu899 時間: 2023-12-28 17:11 標題: The next thing to change is the way Workflow level so that the variables are available in every job. Note that it is generally best practice to expose only the required environment variables to each job individually. For simplicity in this article variables will be exposed to each job. Add the key to your workflow and define the three variables you need to copy At this point you can commit these changes and push them to the branch to publish the changes to the workflow Copy then merge these changes to the branch by running the following command to trigger a new run of the workflow Copy Note In this step you will enter the editor in the terminal. Click and exit the editor. This job will take longer than the unit test job because it must install the startup database and then execute all the tests. After the job completes you should see the following success message Successful integration and unit testing. Adding the End-to-End Test Job Now the unit and integration tests are running in the workflow The last set of tests to be.
Defined are the end-to-end tests. Start by chec photo editing servies ing the branch again to make changes to the workflow file. Copy is similar to how you started in the previous section. Copy the contents of the job into a new job named and replace it with Copy. There are a few things to do before accepting the new job in the virtual Environment Install and Test Browser Update After the steps installed in this job add two new steps for downloading and installing its test browser copy in the project folder. You will also need to add two new environment variables to the installation. The section that will be used when copying should now be properly installed and configured to allow your tests to run when the workflow is run.
The script runs the end-to-end tests. Currently the script is automatically used when the end-to-end test has finished running in an environment where you don't want this to happen as it will cause the job to run endlessly until manually canceled. Remove this line from the script Copy Once the issue is resolved you can now push changes to the branch and merge those changes into the branch Copy If you go back to the browser to view the pull request you should now see three jobs running in the check. The new job will take a long time to complete because it has to download and launch the browser database and perform all the tests. When the job is complete you should see a list of completed successful tests A complete set of summary of successful work and final thoughts In this article you learned about continuous integration. More specifically .
